Reference: |
For information about starting a server, see Verifying Installation.
For information about using and managing a server, see the Server Administration manual.
Command and Option |
Function |
---|---|
edastart |
Starts the server with the line mode console, which enables you to view the server log and to dynamically issue edastart options, such as show, traceon, and stop. To display the console command prompt, press Ctrl + C. |
edastart -start |
Starts the server without the line mode console. |
edastart -sstart n |
Starts the server, but waits n seconds for actual start up. |
edastart -show |
Shows general status of server and agents. |
edastart -stop |
Stops the server. |
edastart -cleardir |
Removes all temporary directories (and their contents), as well as log and other files created by the server (including the rmlda*.log files, if active) in EDACONF. If Resource Manager is in use and you want to maintain the rmlda*.log data, backup the rmlda*.log files before using this feature and restore them afterward. |
edastart -traceon |
Turns on tracing. May be used at startup or afterward. It is preferable to run traces at startup, unless instructed otherwise. Turn tracing on only when there is a problem that needs to be traced, to avoid incurring the associated overhead. |
edastart -traceoff |
Turns off tracing. |
edastart -? |
Displays full set of edastart server control options. |
edastart -?s |
Displays support information and support-related options. |
iWay Software |