In this section: |
|
The SimplePolygonSymbol setting is used to define polygon features on a map. Default parameter values are indicated in brackets [ ].
Take note of the following guidelines when using the SimplePolygonSymbol in your map:
setFillTransparency="0.0"
and
setBoundaryTransparency="0.0"
Do not use setTransparency.
Use setAntialiasing to make the edges of a polygon smoother by padding pixels with intermediate colors. When set to true, antialiasing is active.
Note: When antialiasing is active, the time to generate a map increases.
Parameters:
setAntialiasing="true|false" [false]
Use setBoundary to enable or disable a boundary for a polygon.
Parameters:
setBoundary="true|false" [true]
Use SetBoundaryCapType to specify the boundary cap type value for a polygon.
Parameters:
setBoundaryCapType="butt|round|square" [butt]
Use setBoundaryColor to specify the boundary color of a polygon using RGB values.
Parameters:
setBoundaryColor="0,0,0-255,255,255" [0,0,0]
Use setBoundaryJoinType to specify the boundary join type for a polygon.
Parameters:
setBoundaryJoinType="round|miter|bevel" [round]
Use setBoundaryTransparency to specify the percentage of transparency for the polygon boundaries.
Parameters:
setBoundaryTransparency="0.0-1.0" [1.0]
Note: 1.0 is 0 percent transparent and 0.0 is 100 percent transparent.
Use setBoundaryType to specify the boundary type of a polygon.
Parameters:
setBoundaryType="solid|dash|dot|dash_dot|dash_dot_dot" [solid]
Use setBoundaryWidth to specify the boundary width of a polygon in pixels.
Parameters:
setBoundaryWidth="1-NNN" [1]
Use setFillColor to specify the fill color value of a polygon.
Parameters:
setFillColor="0,0,0-255,255,255" [0,200,0]
Use setFillInterval to specify the distance between lines for hatch fills.
Parameters:
setFillInterval="2-NNN" [6]
Use setFillTransparency to specify the fill transparency value of a polygon.
Parameters:
setFillTransparency="0.0-1.0" [0]
Note: 1.0 is 0 percent transparent and 0.0 is 100 percent transparent.
Use setFillType to specify the fill type of a polygon.
Parameters:
setFillType="solid|bdiagonal|fdiagonal|cross|diagcross|horizontal|
vertical|gray|lightgray|darkgray" [solid]
Use setOverlap to determine if labels can overlap a polygon. When set to true, labels can overlap a polygon. When set to false, labels will not overlap a polygon.
Parameters:
setOverlap="true|false" [true]
Use setTransparency to specify the percentage of transparency for a polygon.
Parameters:
setTransparency="0.0-1.0" [no default]
Note: 1.0 is 0 percent transparent and 0.0 is 100 percent transparent.
WebFOCUS |