Chart Type Syntax Introduction

Reference:

Depending on the type that you are creating, you can:

Use REPORT-VIEW syntax to specify that an active report be displayed as an active chart in a TABLE FILE procedure. You can then use CHART-TYPE syntax to specify one of the chart types supported by Active Technologies, including bar, pie, line, and scatter. Additional chart types are available when the output format is FLEX, including doughnut, area, bubble, radar, funnel, and pyramid.
Use LOOKGRAPH syntax in a GRAPH FILE procedure to generate an available active chart for the output format AHTML, FLEX, or APDF. If there is no corresponding chart type available in Active Technologies, the default bar chart is rendered.

This topic describes the CHART-TYPE syntax and the LOOKGRAPH syntax that you can use to create the available types of active charts.

For the ARGRAPHENGINE and FORMAT settings that generate an active chart, see ARGRAPHENGINE and FORMAT Settings for Active Charts.

Reference: ARGRAPHENGINE and FORMAT Settings for Active Charts

Active Chart	Generated By
FLEX Default Flash Chart	ARGRAPHENGINE=DEFAULT FORMAT FLEX
AHTML Default JavaScript Chart	ARGRAPHENGINE=DEFAULT FORMAT AHTML
FLEX and APDF Flash Chart for Disconnected Mode	ARGRAPHENGINE=FLEX FORMAT FLEX ARGRAPHENGINE=DEFAULT\|FLEX FORMAT APDF
FLEX Flash Chart	ARGRAPHENGINE=FUSION FORMAT AHTML FORMAT FLEX
AHTML JavaScript Chart	ARGRAPHENGINE=JSFUSION FORMAT AHTML
AHTML WebFOCUS Graph	ARGRAPHENGINE=JSCHART FORMAT AHTML

WebFOCUS