The ? SET NOT command produces a list of SET commands that cannot be set in a specific area. The areas for which you can find this information are the PROMPT command, report requests, the FOCPARM profile, and the HLI profile.
? SET NOT area
Is one of the following:
PROMPT is the PROMPT command.
ONTABLE is a report request.
FOCPARM is the FOCPARM profile.
HLIPROF is the HLI profile.
Issuing the command
? SET NOT ONTABLE
produces the following information:
NON-SETTABLE ON TABLE PARAMETER SETTINGS BINS 64 FOC2GIGDB ON PRINTPLUS OFF BLKCALC NEW FOCSTACK SIZE 8 RADIOBUTTON OFF BYPANELING OFF FORMFEED ASCII REBUILDMSG 1000 CACHE 0 HTMLMODE OFF SAVEMATRIX OFF CGI-RELEASE 5200 IFSORT ON SMARTMODE ???? CODEBASE ???? LANGUAGE AMENGLISH SORTNAME XSBEG COLUMNSCROLL OFF TALKCASE OFF DATEDISPLAY OFF MDIBINS 8000 TCPIPINT OFF DATEFNS ON MDIPROGRESS 100000 TEMP DISK D:\ibi\srv8... DATEFORMAT MDY MODE TRMSD 0 DEFCENT 19 MPRINT NEW TRMSW 0 DEFINES OLD NLSCTRL OFF TRMTYP 64 64/S DISTRIBUTE OFF WEBHOME OFF DISTRICT ON WEEKFIRST 7 ERROROUT OFF WIDTH 130 EUROFILE WINPFKEY OLD FIELDNAME NEW YRTHRESH 0