Displaying Parameters That Cannot Be Set in an Area

How to:

The ? SET NOT command produces a list of SET commands that cannot be set in a specific area. The areas for which you can find this information are the PROMPT command, report requests, the FOCPARM profile, and the HLI profile.

Syntax: How to Determine Where a Command Is Valid 

? SET NOT area

where:

area

Is one of the following:

PROMPT is the PROMPT command.

ONTABLE is a report request.

FOCPARM is the FOCPARM profile.

HLIPROF is the HLI profile.

Example: Displaying Parameters That Cannot Be Set With ON TABLE

Issuing the command 

? SET NOT ONTABLE

produces the following information: 

                 NON-SETTABLE ON TABLE PARAMETER SETTINGS 
BINS              64     FOC2GIGDB               ON      PRINTPLUS        OFF
BLKCALC          NEW     FOCSTACK SIZE            8      RADIOBUTTON      OFF 
BYPANELING       OFF     FORMFEED             ASCII      REBUILDMSG      1000 
CACHE              0     HTMLMODE               OFF      SAVEMATRIX       OFF 
CGI-RELEASE     5200     IFSORT                  ON      SMARTMODE       ???? 
CODEBASE        ????     LANGUAGE         AMENGLISH      SORTNAME       XSBEG 
COLUMNSCROLL     OFF     TALKCASE               OFF      DATEDISPLAY      OFF 
MDIBINS         8000     TCPIPINT               OFF      DATEFNS           ON 
MDIPROGRESS   100000     TEMP DISK   D:\ibi\srv8...      DATEFORMAT       MDY 
MODE                     TRMSD                    0      DEFCENT           19 
MPRINT           NEW     TRMSW                    0      DEFINES          OLD 
NLSCTRL          OFF     TRMTYP             64 64/S      DISTRIBUTE       OFF 
WEBHOME          OFF     DISTRICT                ON      WEEKFIRST          7 
ERROROUT         OFF     WIDTH                  130      EUROFILE 
WINPFKEY         OLD     FIELDNAME              NEW      YRTHRESH           0
 WebFOCUS